PIP Lite -- Integrates Ethernet-based IQ Network™ control via 100-Mb TCP/IQ protocol for digital control of analog devices. Since audio signals are not converted to digital, a larger dynamic range is possible. Digital signal control allows for error trapping and a proactive response; provides input compression, multimode average power limiting, peak power limiting, thermal limiter, clip limiting, and load monitoring. Requires FREE IQwic™ software and a computer for initial setup.
Larger Images
Features
- An IQ Network™ Programmable Input Processor with TCP/IQ (connects to an IQ System via 100 Mb Ethernet).
- Remote control and monitoring of PIP2-compatible Crown amplifiers and some PIP1.
- Can be connected to the same network used to pass CobraNet audio.
- Implements SmartAmp features: input compressors, multimode output limiters, error reporting and load monitoring.
- AUX connector configurable for AUX input, AUX output, or Listen Bus.
- Three Year, No-Fault, Fully Transferable Warranty completely protects your investment and guarantees its specifications. (Effective May 1, 2011 when installed into a CTs Series amplifier the warranty is extended to five years.)
Downloads
Documents
| Size | |
PIP-Lite Cut Sheet
updated: Apr 2026
|
210 KB |
|
PIP-Lite Owner's Manual
updated: Apr 2026
|
8.66 MB |
Software
| Size | |
|
|
9.94 MB |
|
|
9.25 MB |
|
|
9.22 MB |
|
|
8.89 MB |
|
|
Declaration Of Conformity
| Size | |
|
|
79.3 KB |
Firmware
| Size | |
|
|
1.43 MB |
|
|
2.02 MB |
|
|
1.99 MB |
|
|
2.5 MB |
|
|
2.11 MB |
|
|
862 KB |
If any of the links above result in strange characters in your browser, please right-click the file to save it to your computer.
Specifications
| Network | RJ-45 connector forming an IEEE 802.3 Ethernet NIC connection |
| AUX | RJ-11 |
| Channel 1 and Channel 2 balanced Inputs | 3-pin, 5mm removable barrier blocks |
| Indicators | A yellow DATA indicator flashes when the IQ-PIP-LITE recieves a valid command that is addressed to the IQ-PIP-LITE. A green PRESET indicator flashes to indicate the selected and active user preset. A yellow LINK ACT indicator (integrated in the network co |
| Memory Backup | 4 Megabit nonvolatile FLASH memory for backup of run-time settings, presets, and program storage. Capable of 10,000 write cycles |
| Power Requirements | No external power is required. 160 mA at +24 VDC and 50 mA at -24 VDC. When installed inot a Crown PIP2 compatible amplifier, the unit receives +/- 24 VDC from the amplifier. |
| Total Power Dissipation | 4.6 watts |
| Input Impedance | Normally 20 kilohms balanced and 10 kilohms unbalanced |
| Maximum Input Level | +20 dBu |
| Dynamic Range | >110 dB (A-Weighted, 20 Hz to 20 kHz) |
| Frequency Response | +/-0.5 dB from 20 Hz - 20 kHz |
| Common Mode Rejection | 50 dB typical |
| THD+Noise | < 0.05% (1 kHz, 0 dBu) |
| Data Acquisition | Eight channel, 12 bit Analog to Digital Converter running at 100 K samples per second |
| Input/Output Monitor Accuracy | Typically +/-1 dB |
Consultant Support