Recommended Posts

ryantoast    0

Help Needed!

what is the correct wiring procedure to mirror a single input to both sides of a Crown CE-1000? which terminals get connected to what?

Thanks in advance

ryandowney@mac.com

Share this post


Link to post
Share on other sites
DGlass    0

To be able to get the same signal on both channels from one input. Install a jumper wire from the + termnal of the channel 1 barrier strip connection to the the + terminal of the Channel 2 barrier strip connection. Then install a jumper wire from the - termnal of the channel 1 barrier strip connection to the the - terminal of the Channel 2 barrier strip connection. You will not need to put in a ground wire jumper as ground is already common to both channels.

This would be the same as putting an XLR "Y" cable on the input XLR connectors allowing you the have the same input signal from a single XLR connection to both input channels of the amplifier.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now