rezsbc

I-Tech....Y input?

Recommended Posts

rezsbc    0

Hey,

I'm sure I'm doing something really stupid but when I set an I-Tech 6000 up the other day it seemed to be stuck on "Y" input no matter what setting I made on the IQ-Wic software (on the block diagram screen for the amp).

Is there something I'm missing here is there somewhere else this can be set? Need to run in stereo.

ites.,

cathal.

Share this post


Link to post
Share on other sites
Hey,

I'm sure I'm doing something really stupid but when I set an I-Tech 6000 up the other day it seemed to be stuck on "Y" input no matter what setting I made on the IQ-Wic software (on the block diagram screen for the amp). 

Is there something I'm missing here is there somewhere else this can be set?  Need to run in stereo.

ites.,

cathal.

1881[/snapback]

There are actually two places you can make this adjustment. One is the input "Y" as you mentioned. The other place to check is the Input Section and make sure that the amplifiers are receiving signal from the proper channels

post-2-1127783016_thumb.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now