Crown XLS 402 with Tronographic Rusty Box

Recommended Posts

Shellac    0

Hello! I am looking for some advice on how to use a 'Tronographic Rusty box' pedal as a pre-amp with a Crown XLS 402.

I am a bass player and have just purchased a second hand Crown XLS 402. The idea was to use a 'Tronographic Rusty box' pedal as a pre-amp into the XLS 402 and use a single channels output to an Ampeg 4x10 (500w @4ohm).

As the XLS 402 only has XLR inputs, I am using a 1/4" jack to female XLR running from the Rusty Box's Line output into the XLS's 1st channel input.

I have stripped down one end of an old Speakon cable and have exposed the black and red cables. I have attached the red and black bare wire to the binding posts of Channel 1's output.

I was hoping to use just one side of the stereo output, 450w @4ohm, to power my speaker cabinet. Is this possible or have I totally dropped the ball?

Has anyone else been successful with this type of setup?

I would appreciate any feedback.

Many thanks!

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now