Recommended Posts

Just got a new setup and trying to figure out the best way to get the most out of it. i have the fillowing:

2 JBL SRX 715's

1 JBL SRX 728

2 XTI2 4002 currently bridged 8 ohm's one to each 715

1 PLx 3602 bridged mono to the 728

1 drive rack

and various other Mobile DJ equipment..

how should this be setup to protect the equipment and get the best and loudest sound.

thanks

ken smith

smithkj133@comcast.net

Share this post


Link to post
Share on other sites
dakos    0
Just got a new setup and trying to figure out the best way to get the most out of it. i have the fillowing:

2 JBL SRX 715's

1 JBL SRX 728

2 XTI2 4002 currently bridged 8 ohm's one to each 715

1 PLx 3602 bridged mono to the 728

1 drive rack

and various other Mobile DJ equipment..

how should this be setup to protect the equipment and get the best and loudest sound.

thanks

ken smith

smithkj133@comcast.net

Welcome to the forums...

Do you have a bigger amp for the subs? The 3602 is bridged into 4 ohm load and that's not recommended and doesn't sound that good.

Other then that I assume you use the DR wizard to configure your system, it's usually doing a great gob at that. Which DR is it?

Other then that you're pretty much at the max of what the amps can deliver.

Share this post


Link to post
Share on other sites
Just got a new setup and trying to figure out the best way to get the most out of it. i have the fillowing:

2 JBL SRX 715's

1 JBL SRX 728

2 XTI2 4002 currently bridged 8 ohm's one to each 715

1 PLx 3602 bridged mono to the 728

1 drive rack

and various other Mobile DJ equipment..

how should this be setup to protect the equipment and get the best and loudest sound.

thanks

ken smith

smithkj133@comcast.net

Welcome to the forums...

Do you have a bigger amp for the subs? The 3602 is bridged into 4 ohm load and that's not recommended and doesn't sound that good.

Other then that I assume you use the DR wizard to configure your system, it's usually doing a great gob at that. Which DR is it?

Other then that you're pretty much at the max of what the amps can deliver.

thanks

right now these are the only ones i have. i will be upgrading the qsc to a ma 5000 or 9000 for the sub.

will the xti 4002 not power the 715 properly?

Share this post


Link to post
Share on other sites
dakos    0

If it's bridged on each 715 then you have what they need. They can take just a little more (3600W instead of the 2400W) but it wouldn't make an audible difference cause it's less then 3dB.

Try to get the MA9000i, it's a better fit.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now