Recommended Posts

sonny    0

I've got a question about the input signals into a Crown 3600VZ. The 3600 has 2 xlr inputs which are normally used in stereo. I was wondering if a signal was sent to the chl 1 xlr... could I then link the signal to chl 2 by inserting a TRS into the female input on chl 1... and then link to chl 2. I am not attempting to bridge or mono parallel. I just want the signal sent to chl 1 looped to chl 2...

thanks

Share this post


Link to post
Share on other sites
dakos    0
I've got a question about the input signals into a Crown 3600VZ. The 3600 has 2 xlr inputs which are normally used in stereo. I was wondering if a signal was sent to the chl 1 xlr... could I then link the signal to chl 2 by inserting a TRS into the female input on chl 1... and then link to chl 2. I am not attempting to bridge or mono parallel. I just want the signal sent to chl 1 looped to chl 2...

thanks

If you are using the internal PIP effects box then the TRS is NOT just connected in parallel to the XLR, so if you want to loop the signal you have to loop TRS to TRS and NOT TRS to XLR.

If you are NOT using the internal PIP effects box, and you just have the default PIP INTERCONNECT box, then the TRS is just connected in parallel to the XLR, so if you want to loop the signal you can use TRS to TRS or TRS to XLR.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now