Lowell2k9

2 XTI 4002 Amp & 2 JBL srx 18S Setup

Recommended Posts

Lowell2k9    0

Hello guys, I recently purchased (2) XTI 4002 amps & (2) JBL SRX 18S along with Drive rack PA. This is a setup question, chime in please.... Can I run

each sub with its own XTI4002 amp in bridge mono (will this be too much power)? or would it be best to just run (1) XTI to both jbl srx 18's in bridge mode (and/or

will this setup be under powered)?

Share this post


Link to post
Share on other sites
Lowell2k9    0
Hello guys, I recently purchased (2) XTI 4002 amps & (2) JBL SRX 18S along with Drive rack PA. This is a setup question, chime in please.... Can I run

each sub with its own XTI4002 amp in bridge mono (will this be too much power)? or would it be best to just run (1) XTI to both jbl srx 18's in bridge mode (and/or

will this setup be under powered)?

Share this post


Link to post
Share on other sites
dakos    0
Hello guys, I recently purchased (2) XTI 4002 amps & (2) JBL SRX 18S along with Drive rack PA. This is a setup question, chime in please.... Can I run

each sub with its own XTI4002 amp in bridge mono (will this be too much power)? or would it be best to just run (1) XTI to both jbl srx 18's in bridge mode (and/or

will this setup be under powered)?

Two 718's on one 4002 sounds good only on paper, in reality it will work but it wouldn't sound that well, one bridge mono on each 718 is a much better combination. I'm not sure even limiting is required but keep your ears open for distortion and back up a little.

If you want to limit the amps then a 1600W limitation is where you should aim at.

Look here for the calculation on what to enter in the DSP or use system architect for simpler configuration.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now