Sign in to follow this  
The Fossil

XLS 5000 & Peavey SP 6 towers

Recommended Posts

The Fossil    0

I currently have a 3 year old Crown XLS 5000 running my FOH Peavey SP 6 speakers. The Peaveys are 4 ohm Quasi 4 way towers rated at 2000 watts program / 4000 watts peak. I've been told by several people including the music store owner who sold me the Peavey speakers that the Crown XLS 5000 is WAY TOO MUCH amp for these speakers. From all I can find out, the XLS 5000 is rated at 1800 watts per channel @ 4 ohms in stereo mode.

I can't afford to trade or buy different equipment right now, so I'll have to go with what I have. My main questions are:

1. Is this in fact too much amp for the speakers I have?

2. How far should I be turning up the volume knobs on the Crown? 1/4, 1/2, 3/4, or all the way clockwise? (I've been told that Peavey reccomends running THEIR amps at wide open). What does Crown reccomend?

I am fearful of doing damage to the speaker components.

This is why I am considering the purchase of the Peavey VSX 26 Speaker Management Processor unit to protect the speakers from getting too much power, if this is the case with this amp.

Thank you for your time,

The Fossil (Kim)

Share this post


Link to post
Share on other sites
tlureman    0

This amp is actually a pretty good match up for the amp. Like you said, it can do 1800W into a 4ohm load, which is right around the target range given by the program power.

You can have the knob is whatever position you like. It depends on your preference is you want control at the amp or the board.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this