XTI's unable to deactivate crossover

Recommended Posts

parkerrobb    0

Hey, I just purchased two XTI's and have a problem getting different mixes with the monitors.I ran two signals from the amp from AUX 1 and 2 in the board. However I cannot get a separate mix for the two channels. The Amp output ch1 and ch2 want to respond like bass and tweeter and I cannot separate the channels. I have made sure the internal crossover is switched off in the setting I am using. However continues to split the Lo and Hi end.

Any suggestions would be great.

Share this post

Link to post
Share on other sites
tlureman    0

Load Preset 1 "DSP OFF". Try switching inputs 1 and 2 to make sure it's not on the input side. If that doesn't work put the inputs back to their initial state and switch the speakers.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now