e_c_mccollum

macrotech 2400

Recommended Posts

Got a macrotech 2400 with an odep issue. The odep lights are bright when powering up with no signal. With signal applied, amp in stereo mode, ch. 2 odep light goes out. Going to clean amp out and check for soldering. Any other ideas?

Speakers ,cables, and inputs are good.

Share this post


Link to post
Share on other sites
Kevin Heber    0

ODEP light on is of course normal. So it goes out immediately when signal is applied? This means the amp thinks it is going into thermal overload. Service is probably the way to go.

Share this post


Link to post
Share on other sites
ODEP light on is of course normal. So it goes out immediately when signal is applied? This means the amp thinks it is going into thermal overload. Service is probably the way to go.

Goes out when signal is applied and comes back on when signal is gone. Odep circuit malfuntioning? Odep not biased properly?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now