Recommended Posts

bakkker7544    0

I have the orginal pip cards in my IQ System and I need to cahnge the address on one card, or I need to figure out the address. so if anyone could give me the code for the dip switches so that I can interpret or cahnge them that would be great.


Share this post

Link to post
Share on other sites
DGlass    0

Some of the older cards used a Red Dip Switch that you had to Push the tabs down to set them to on. I have attached an Address table from the USP-2 it's the same Binary is Binary whether you push the switch up or Down.

There is currently not a manual available for the original IQ-PIP module in .pdf. I will work on getting it scanned in and posted on the Legacy Discontinued Products web page as soon as possible.


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now