Communication issues old Iq/New Iq

Recommended Posts

bakkker7544    0

I recently installe an IQ interface 3 to work with my old IQ system. The problem that I have is that I have a break in the line before the first input of amp #1. I don't know where the break is.

The description of my system is that I go from the interface into my first pip card which is a IQ P.I.P. ver 1.04 and then through approximately 14 other amps with the same pip cards and back into the interface. 12 are located in an amp room approximately 125' away and two amps that are located with in 10 feet of the interface.

I thought that I had a bad lcommunication line from the booth to the amp room. O I decided to make the communiocations happen in the control room to make sure that everything was working here and then add amps to confirm that everything works. I again recieved the same message, that the break is before the first input of amp #1 Do I have a bad card do I have a bad ethernet cable that I connected to the din connector? How can I continue to troubleshoot?

Thanks For your help and sorry about the long winded message

Share this post

Link to post
Share on other sites
DGlass    0

It does sound like you may have a bad PIP card. You may have to Isolate down to one PIP card try the system and then add one at a time back into the loop until you find the bad PIP.

On the Crown Legacy web page is an "IQ System Trouble shooting Guide" .pdf file from the old IQ Training School Manual. This guide has the procedures for troubleshooting an IQ 20ma current loop system.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now