Sign in to follow this  
ray fishel

SA - Re-numbering CDi amps won't follow to custom pages

Recommended Posts

ray fishel    0

I use quite a few CDi/SDi amps in systems and have written some extensive custom pages.

I'll have a master page that will be an overall EQ and it uses all of the output Eq's.

I then have pages that control individual zones such as main cluster hi, main cluster low, down fill, delay ring, under balcony and so on.

One thing I didn't think of was to code the amps for the zones such as 100's, 200's 300's & so on so if I have 4 sub amps, I number them 101, 102, 103, 104.

changing things over should be simple but when i renumber the amps, channel 2 on all the controls are asigned to channel 1. I have the same number of Parameter addresses that I started with but nothing for channel 2 on any of the amps that I want to renumber. I'm basically telling channel 1 to do something twice.

It would be real cool if this bug could be fixed.

It would also be real cool if the master panels could be broken out the way I'm trying to do.

This doesn't happen with the I-Techs or CTs-USP-3 amps as far as I can tell.

I hope I explained it well.

I looked through the forum and didn't see anyone else ask about this so I hope I'm not covering old ground.

Share this post


Link to post
Share on other sites
ray fishel    0

I was informed that I'm now the proud father of a bug.

I'm not sure what my wife will think but my kids already want to keep it as a pet. :)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this