Problems With Ultra tech 1010

Recommended Posts

z9laserr    0

<_< HI! My Ultra-Tech 1010 amp has no fault signal in the front panel but for some reason has no output in any of the two channels. I make differents changes of wiring and speakers but the wiring and the speakers are in exellent condition.

I use this amp exclusive for my guitar processor Digitech 2101 in stereo mode and always take good care it. The input signal light comes on when I play the guitar and the processor output is working because I verify with other amps. I always take care not to turn on the clip signal because I use a very low sound compare with the power of the crow amp. I verify visually inside of the amp but I don't see any burnt or damage component. Please let me know what I can do or if you can send to me a electronic circuit schematic because according to the online manual if the amp has no output it's suppose to turn on the fault signal but it does not.



Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now