Problem with Macrotech 3600 VZ

Recommended Posts

gustaudio    0

Dear friends I´m repairing a Macrotech 3600 VZ, the channel 2 have a distorsión. When I turn up the volume at the medium level (aprox), teh output wave form is ok, but when turn it up a little more, the negative portion of the sine wave desapear. I check the output transistors, they are ok, check the power supply voltage they look like teh other channel (the good one), I interchange teh PCB´s that have the 6900 uF capacitors...nothing happened, the problem still in channel 2, I think that the problem is in the switching area of the amplifier, but I need some sugestions, Please any body...

Thank you and best regards.

Gustavo Contreras :)

Share this post

Link to post
Share on other sites
dannyavila    0

Hi Gustavo:

If the amp's sine wave negative side "disappears" at certain power level, it could be caused by an output current control circuit defective part. Did you check all the 0.33 Ohm/5 Watt output resistances, Q107-108 and Q124-125 BJTs or U104 (MC33079) conditions? In some cases, a missing cooper trace in the main board around the "Mode" switch area caused this symptom to appears randomly.

Kind regards,

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now