baszslap

Itech 4000 problems

Recommended Posts

baszslap    0

Hi I'm Stefan from Romania and I have a BIG problem with my gear (please excuse me...my english is not extraordinary)

I just bought a ITech 4000 and a couple of JBL SRX715+SRX718s and i don't know how to set them up. The amp delivers something like 200-300w when is at 95% . I linked the Itech to my laptop (after a couple of hours of pure pain :lol: ) but i don't know what to change in order to make my Itech to work in its normal parameters.

best regards

P.S.

( the person that bought this gear for me told me that the Itech 4000 that tested in the shop had the same problem and the guy at the store made it work after talking with someone from CROWN )

Share this post


Link to post
Share on other sites
DGlass    0
Hi I'm Stefan from Romania and I have a BIG problem with my gear (please  excuse me...my english is not extraordinary)

I just  bought a ITech 4000 and a couple of JBL SRX715+SRX718s and i don't know how to set them up. The amp delivers something like 200-300w when is at 95% . I linked the Itech to my laptop (after a couple of hours of pure pain  :lol: ) but i don't know what to change in order to make my Itech to  work in    its normal parameters.

best regards

P.S.

( the person that bought  this gear for me told me that  the Itech 4000 that tested in the shop had the same problem and the guy at the store made it work after talking with someone  from CROWN )

4027[/snapback]

Try recalling a preset that is not being used this will wipe any bad settings that may be setup in the amp. This can be done from the front panel or by the software.

If that doesn't work I will send you the amp reset procedure that will wipe all the settings except the IP and MAC addresses.

Share this post


Link to post
Share on other sites
DGlass    0
well my amp has no presets at all ... and  i don't know how to "recall a preset that is not being used" cand u please teach me ...

thank you

Stefan DAN

4064[/snapback]

*Depress the "Menu" button once. It will display the contrast window.

*Depress the "Next" button three time to get to the "Presets" window.

*Rotate either of the front panel Encoders (Level Controls) until you get to a preset number of your choosing.

*Depress either one of the Encoder knobs (Level Controls) to select the Preset.

*A confirmation window will pop up requesting you to confirm loading the Preset by depressing and holding the Encoder knob (Level Control).

*Depress and hold the Encoder (Level Control) until you see a pop up window that says "Preset x Loaded" (were "x" is the number of the Preset being loaded.

*Preset is recalled.

This is also described in the owners manual under the "Advanced Operation" Section 4.2.2 "Presets:"

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now