paul beale

Repair of CJ2000d

Recommended Posts

paul beale    0

Hello All,

I am repairing a crown amp with shorted output transistors in one

ch. I have replaced one in the high side and one in the low side. I checked

characteristics with curve tracer to be sure of gain match. Also replacements

have same green mark on case and same part number. Is it required to replace all outputs or is this OK? It is not blowing fuses anymore but still in protect mode. It has 100v on speaker output relay.

I am having extreme difficulty with documentation.

Crown supplies JBL Pro. with crude Photocopy PDF files of engineering diagrams with holes and bad spots that can not be read , instead of service manuals.

This is a revision 5 amplifier that was made just a few months ago. It is

installed in a JBL Mpro sub cabinet. I see a fair number of older ones of these, but rarely with bad output transistors.

At flat rate warranty repair I am losing my shirt....... I cannot locate a manual

and the JBL supplied Crown schematic diagrams are NOT readable. This amp is

quite different from previous revisions.

Paul Beale

Share this post


Link to post
Share on other sites
DGlass    0
Hello All,

        I am repairing a crown amp with shorted output transistors in one

ch.  I have replaced one in the high side and one in the low side. I checked

characteristics with curve tracer to be sure of gain match. Also replacements

have same green mark on case and same part number. Is it required to replace all outputs or is this OK?  It is not blowing fuses anymore but still in protect mode. It has 100v on speaker output relay.   

        I am having extreme difficulty with documentation.

Crown supplies JBL Pro.  with crude Photocopy PDF files of engineering diagrams with holes and bad spots that can not be read , instead of service manuals.

  This is a  revision 5 amplifier  that was made just a few months ago. It is

installed in a JBL Mpro sub cabinet.  I see a fair number of older ones of these, but rarely with bad output transistors.

        At flat rate warranty repair I am losing my shirt....... I cannot locate a manual

and  the JBL supplied  Crown schematic  diagrams are NOT readable.  This amp is

quite different  from previous  revisions.

Paul Beale

4005[/snapback]

The CJ amplifiers are a built to order product manufactured by Crown on the design and specifications of JBL and are a "JBL" product. As an OEM manufacture of the product Crown is not responsible for manuals or service documentation. All questions and inquiries on this product need to go to JBL.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.