Recommended Posts

harcur_75    0

hi there,

I need to some help i have a crown cts 1200 when i used it and i set the volume control both channel at half level after a seconds ch. 2 was clipped...please give some troubleshooting tips..tnx!

Share this post


Link to post
Share on other sites
DGlass    0
hi there,

I need to some help i have a crown cts 1200 when i used it and i set the volume control both channel at half level after a seconds ch. 2 was clipped...please give some troubleshooting tips..tnx!

3807[/snapback]

Is the amp in Dual Channel or Mono Mode?

How hard are you driving the inputs?

Are both channels receiving the same signal?

Have you changed the input sensitivity settings on one channel?

Have you switched the inputs to see if it is an input signal problem?

Does the problem go to the other side when you switch inputs?

Have you switched the outputs to see if it is a load problem?

Does the problem go to the other side when you switch outputs?

Share this post


Link to post
Share on other sites
joust    0

The CTS1200 clip circuit also monitors the input signal. If the output signal doesn't appear to clip because of headroom limitation (ie: low volume...) then the clip lite indicates that the input circuit detected excessive signal. Adjust sensitivity switch to an appropriate setting and/or lower the level controls.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now