gradyex

Members
  • Content count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

About gradyex

Contact Methods

  • ICQ
    0
  1. lockout options

    Hold the right two buttons down for about 6 seconds. During that time, the screen will say locked, it will quit displaying the word locked, and a few seconds later it will say unlocked. Locking is performed by holding the same two buttons down for the same amount of time. 3378[/snapback] I am sorry the thanks goes to JGRIGGS. See previous post.
  2. lockout options

    I will email you the proceedure but it will reset the amps to factory default. You will have to reset addressing and reload your programming. 2631[/snapback] I am having the same problem with my XTi 1000 that I just set up today. I looked in the manual but there is nothing stated on how to "unlock" this. Basically I can't do anything as far as adjustments go so I am stuck. Would love to know how to unlock it too. Thanks. 3369[/snapback] Fantastic, it worked! Thanks so much for the imput. I must of accidently pressed the 2 right keys to activate it. I have one more quick question (I am a novice at this so bear with me), if you had one Crown XTi 1000amp, one QSC 3002amp, and one Nandy XA 2100amp, with a stereo signal comming from a Mackie Onyx 1640 using a dbx 234 crossover running 3 speakers, 2 JBL MP415's and one JBL MP418 non powered subwoofer, how would you hook it up? The speakers have 2 Neutrik inputs each (a top and bottom imput where one can be used to send its imput signal to another speaker). Can you send 2 seperate signals to each speaker (example a high frequency on chanel 2 of the Crown and a low frequency on channel 1 going to the same speaker)? Currently I am running the QSC amp in stereo mode to the 2 JBL MP415's (bypassing the crossover) and the Crown in bridged mode taking the "summed low" signals from the crossover to channel 1. I am not using the Nandy at all. Any advise would be appreciated and thanks again. Would you use all 3 amps or just 2 and how would you configure them? This is for a small studio in my basement where I use the JBL's mostly for monitoring purposes.
  3. XTi System Architech

    Hello AFlint,Will the software come in a Mac version as well as Win/PC? Thanks. 3263[/snapback] The Harman Pro "System Architecture" software is a MS Windows OS platform only. With the advent of the new Macs being dual platform with Intel chips this should not be to much of an issue in the future. 3264[/snapback] I am having lock out issues with my XTI 1000, also the fan can get real noisy at times. I hope this is addressed in the update (unfortunately I have a Mac) so it looks like I will have to borrow a PC in order to update the firmware when it comes out.
  4. lockout options

    I will email you the proceedure but it will reset the amps to factory default. You will have to reset addressing and reload your programming. 2631[/snapback] I am having the same problem with my XTi 1000 that I just set up today. I looked in the manual but there is nothing stated on how to "unlock" this. Basically I can't do anything as far as adjustments go so I am stuck. Would love to know how to unlock it too. Thanks.