• Content count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About wolff46

  1. Replaced the voltage regulator (got a 56 uf cap instead of a 560 so put the old one back in) now I'm just getting a thermal warning
  2. I'm not sure which side it was on. Ordered the parts should have them replaced tomorrow. Will let you know how that goes. Thanks again for your help.
  3. I have a crown cts 1200 that when it is powered with no input, and with one 8 ohm speaker connected to either ch 1 ch2 or bridged I get a steady level hum, like a ground loop. Also the ch 2 clip light will come on and stay lit. Sometimes giving it a firm tap will blink the clip light out . Any suggestions on troubleshooting? I have the board out and have inspected solders as best I could. Have a multimeter as my only diagnostic device