• Content count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About ryano

  1. Hey Folks, This is probably a silly question but I haven't been able to find an answer in this forum or gleam it from the manual. I have a 402D amp and I would like to drive two cabs off this amp, meaning stereo mode. The question I have is; can I drive two cabs using stereo mode with a single input or do I need some kind of Y cable to send the same input signal to both outputs? As an example, say I have a 4 ohm and 8 ohm cab and I prefer to run the amp in stereo mode, since I believe it is fine to run the amp using different loads per output, but I would like to send input 1 to both output channels (no input 2). What would be the appropriate way to do this? Sorry if this is obvious. Thanks in advance. --ryano