Another method: Rubber-band some windscreen foam around the mic cable about 1.5 inches from the mic capsule. Stuff the foam in the tailpiece, and position the mic so it "floats" over the fiddle body, midway between the tailpiece and bridge. Some people tape the GLM to the strings on the player's side of the bridge, and then turn down the high-frequency EQ (treble) until the fiddle sounds natural.
Another user's question:
I've been surfing the net for info about how to properly position my GLM-200 on my fiddle and found your site. I stick a bit of blue tack on my tailpiece between the G and D strings, and rest the mic in it so it is sitting just behind the bridge facing down. I love the warm sound and the freedom of movement. I have two big problems though: one is I occasionally exhale onto the fiddle and get a massive roar. The other is I get a lot of fingerboard noise, thudding and bumping as I cruise through my jigs and reels. Any advice on how to treat these problems and not lose the nice sound I'm getting with the mic in that position?
Reply: Here's a suggestion on shock-mounting the GLM-200 to a violin:
Take a regular-size microphone foam windscreen, or some foam rubber from a pillow, and cut a strip of foam about 1" x 3" x 1/4" thick. Wrap the foam strip around the GLM mic cable, about 1.5 inches from the mic capsule.
Stuff this foam cylinder under the tailpiece (between the tailpiece and the violin body). The mic capsule will "float" between the strings and body on the tailpiece side of the bridge. Make sure the front of the mic is aiming at the violin body (it's labeled "Front").
For breath protection, you might want to attach some thin silk or nylon fabric to the top surface of the strings on the tailpiece side of the bridge, so that the mic is covered by this wind filter. There will be an airspace between the mic and fabric.
You might also cut low frequencies on your mixer's violin channel below 200 Hz, because wind noise is mostly at low frequencies. That low-cut will reduce handling noise as well.
If the sound is too bassy, roll off or turn down some low frequencies (at about 200 Hz) on your mixer's equalizer until the sound is natural. That will reduce feedback as well. Similarly, if the sound is too trebly, turn down the high frequencies around 10kHz until the sound is natural.
Since a violin is a resonant cavity, putting a GLM inside is exacerbating any feedback. The GLM-100 has an omnidirectional pattern, while the GLM-200 has a hypercardioid pattern. The hypercardioid pattern is severely degraded by putting the GLM-200 inside the violin, so it's better to keep the GLM-200 outside the violin.
Another user's question:
I am interested in using a mic for my fiddle. I see on Fishman's website that they offer a Fishman 200M pickup and a Crown GLM-200E mic. Does Crown offer the GLM-200E with any type of chinrest type clamp for mounting to a violin? Also, do you have any recommendations on how the mic should best be set up?
Reply: The GLM-200E is already wired with the pickup in Fishman's V-200M pickup/mic system. Although Crown does not make a chinrest clamp, Fishman has worked out a way to mount the mic on a fiddle. The mic-mounting gooseneck is attached to the Fishman jack bracket, and the mic is pointed toward the instrument near an f-hole. The best placement will vary depending on the instrument.