Search:     Advanced search
Glossary
Knowledge Base / Networked products / What is the difference between IQ-PIP Lite and MEM and SMT?


What is the difference between IQ-PIP Lite and MEM and SMT?
The IQ PIP Lite is more than 2,000 times faster No IQ Address DIP switches for the PIP Lite. Load Monitoring (not available in MEM) The PIP Lite Costs less than the MEM or SMT The PIP Lite does not require PIP1 SIP Resistors The PIP Lite has a Maximum Input is +20dBu resultiing in Greater Dynamic Range An IQ NetworkT Programmable Input Processor with TCP/IQ (connects to an IQ Network via 100 Mb Ethernet). Can be connected to the same network used to pass CobraNet audio. AUX connector configurable for AUX input, AUX output , or Listen Bus . The PIP Lite has: Input Compressors Multimode Output Limiters Error Reporting Load Monitoring Line Voltage Monitoring Firmware downloadable via TCP/IQ 10 Presets stored on the card Reliable FLASH memory backup of all parameters.
Others in this Category
document Where can I find retail prices for Crown products?
document How much faster is TCP/IQ than the IQ Bus ?
document How do I assign addresses, either IQ, TCP/IQ, TCP/IP, Subnet Mask, or Cobranet?
document Will the new TCP/IQ products work with the 20 mill current loop products?
document What is a Mac Address?
document Why are there IQ and TCP/IP addresses?
document How do I change a Mac Address?
document What amplifiers do the IQ-PIP-Lite work with?
document When will the BSS 8810C be able to talk TCP/IQ?
document What amplifiers do the IQ-PIP-USP3 work with?
document What amplifiers do the IQ-PIP-USP3/CN work with?
document I have set up a TCP/IP address and a default gateway, but I can not see the products on another VLAN.
document What is the difference between USP3/CN and a USP2/CN?
document Why are there IQ addresses greater than 250, I thought those were not allowed
document Why are there so many addresses, IQ, TCP/IQ, and Mac Address?
document How do I save a preset in a USM-810?
document How do I save a preset on a PIP card?
document How do I assign a control to the USM810 control port?
document How can I lock the front panel of the USM-810?
document How do I readdress components?
document Why does my CTs amplifier show 100% ODEP with USP2 and USP2/CN Cards?
document What are the differences between IQ-PIP modules?
document What are the compatibility issues I need to worry about with IQ-PIP modules?
document How do I store presets in the IQ-USM 810 and IQ-PIP-USP2?
document What Crown IQ components can serve as system interface?
document Why can't I get my PC to communicate with the interface?
document How do I purchase Crown Products?
document I don't know anything about networking. Can I get I-Tech's networking up and running quickly without reading a book or taking a class?
document USM-810 / PS8810 cycles sh1,sh2,sh3,sh4. Can I fix it?
document A USM-810 / PS-8810 shows an "E" error code. What is it?
document What PIP modules are compatable with what amps?
document How do I update the firmware in my CDi, DSi, or XTi amplifier for use with System Architect?


Powered by KnowledgebasePublisher (Knowledgebase software)