Crown Audio by Harman

Search:     Advanced search
Glossary



Where should I place a Sound Grabber at a wedding so the sound is not boomy?

I just bought a Sound Grabber II to use for wedding videos. The microphone 's sound was somewhat "boomy" when the mic was on the floor 2 feet from me. Any suggestions?
Mike Sparkes

Reply: Like any microphone, the Sound Grabber gets less boomy (picks up less room reverb) as it is placed closer to the sound source. A typical mic placement for a wedding is on the floor between the worship leader and the marital couple. Do a trial recording of your own voice with the mic in that position. If it sounds too reverberant, use a lavalier mic (like a GLM-100) on the worship leader.  
Others in this Category
document Should I use a Sound Grabber or GLM-100 to mike a piano?
document How do I connect a PZM-185 or Sound Grabber II to my camcorder?
document How can I convert a Sound Grabber to be phantom powered?
document Why does my Sound Grabber have a low signal level?
document How can I record a rock-group demo with Sound Grabber mics?
document Can the Sound Grabber boundary be clear plastic?
document Will a Sound Grabber II work with a computer sound card?
document How can I power a Sound Grabber II from a sound card?
document How can I record a conference with a Sound Grabber II?
document Will a Sound Grabber II work to pick up students in a classroom?
document What connector mates with a Sound Grabber II? How do I order the Sound Grabber II online?
document Is there a mic extension cable for the Sound Grabber II?
document PZM-185 output level vs. Sound Grabber II output level
document Miking flute recitals with flat floor mics
document Which Crown microphone has a connector that fits a mini digital camcorder?
document Sound Grabber II or PZM-185?