Crown Audio by Harman

Search:     Advanced search
Glossary



How do I wire a CM-311AE or CM-312AE to a Sennheiser Evolution transmitter?

The Crown CM-311AE or CM-312AE headworn mic works with Sennheiser's new Evolution G2 transmitter. You'll need to solder a 3.5mm (mini) stereo phone plug to the end of the mic cable, ideally using a locking phone plug from Sennheiser. Solder the mic-cable red lead to tip, white to ring, and shield to sleeve. Use the transmitter's menu to change the sensitivity from 30 dB to 0 dB. The mic will work dependably for at least 10 hours without changing batteries.

The transmitter's battery life can be extended if you modify the transmitter’s electronics. Sennheiser supplied a diagram that shows how to do it:

If the signal level is too low, Sennheiser has suggested wiring the white and red leads to the phone-plug tip. However, the EQ circuit that is inline with the cable does not work with that wiring. To get a higher output signal, you could cut off the EQ circuit, then solder the white and red leads to tip. Then the bass will be very weak. You will need to turn up the bass (low frequencies) on your mixer EQ to compensate. That might be an acceptable solution.

Others in this Category
document How do I prevent turn-on pops with the CM-311A?
document What are the pop filters for the CM-311A?
document How do I reduce breath pops with the CM-311AE?
document How do I make a CM-311AE or CM-312AE hard wired?
document How do I fit the CM-311A or CM-311AE to my head?
document How do I convert a CM-311A to wireless?
document Where else can I attach the CM-311A beltpack?
document How do I reduce drum pickup with the CM-311A?
document How do I control boom bounce in the CM-311A?
document Should I run my CM-311A off phantom power, or use the battery in the beltpack?
document What's the difference between the CM-311AE and the CM-312AE?
document Should the CM-311AE distort?
document How can I protect the mic capsule in my CM-312A?
document How do I wire my CM-311AE or CM-312AE to a Mipro transmitter?
document Help choosing a headset microphone
document Compatible wireless systems for GLM-100E, CM-311AE or CM-312AE
document How do I prevent breath pops with the CM-311A?