Crown Audio by Harman

Search:     Advanced search
Glossary



I am using an IQ Systems Interface with a USM-810 and USP-2 cards. The USM-810 Control Panel will not load in IQ for Windows and an error code of 16320 is displayed.

In this situation the USM-810 and USP-2 versions 1.001 or earlier are connected on the same loop of an IQ System Interface (INT2 or INT3). This was a firmware glitch and the problem will not occur if the USM-810 is on a separate Loop .

 

Resolution: USP-2 firmware 1.002 or later is needed for same loop operation of a USM-810 and USP-2 modules on an IQ System Interface. Firmware chips can be obtained for the USP-2 from the Crown Parts Department and the USM-810 firmware is available for download from the Crown Web Site.

Others in this Category
document An IQ Client computer, running IQ for Windows, cannot communicate with an IQ Net Server computer.
document My SMX-6/AMB-5 looses memory after a power outage.
document The Monitor Selector thumb wheel doen't work on my SLM-8.
document When trying to display curves, from an SLM-8, the software locks up and crashes.
document My INT-II (INT-2) is not located by IQ for Windows Roll Call
document Using an INT-II (INT-2), IQ for Windows Roll Call doesn't find my devices and only gives a CTS low statement.
document After using a modem and an INTII (INT2) the IQ for Windows Roll no devices are found.
document INT Interface (not INT2) doesn't find components on Loop after moving loop connectors to different Loop.
document INT (not INT2) unable to find or communicate with IQ2 devices.
document Audio polarity of IQ PIP SLM is reversed
document IQ PIP DSP has crackling noise and the noise floor is elevated and input meters show -20 to -15dbu input with no signal input
document I am using a 10k potentiometer on the USM-810 Control Port and it is not working.
document When running an IQ for Windows Roll Call the Interface is discoverd but no IQ devices are seen.
document What PIP modules are compatable with what amps?
document With two or more USM-810's in a IQ system engaging the preset in one of the USM-810's (that is not the Interface) causes the unit to lock up and go offline. Aftera period of time the unit comes back on line.