Audio polarity of IQ PIP SLM is reversed

This was a design error it is reversed.

Others in this Category

	An IQ Client computer, running IQ for Windows, cannot communicate with an IQ Net Server computer.
	My SMX-6/AMB-5 looses memory after a power outage.
	The Monitor Selector thumb wheel doen't work on my SLM-8.
	When trying to display curves, from an SLM-8, the software locks up and crashes.
	My INT-II (INT-2) is not located by IQ for Windows Roll Call
	Using an INT-II (INT-2), IQ for Windows Roll Call doesn't find my devices and only gives a CTS low statement.
	After using a modem and an INTII (INT2) the IQ for Windows Roll no devices are found.
	INT Interface (not INT2) doesn't find components on Loop after moving loop connectors to different Loop.
	INT (not INT2) unable to find or communicate with IQ2 devices.
	IQ PIP DSP has crackling noise and the noise floor is elevated and input meters show -20 to -15dbu input with no signal input
	I am using an IQ Systems Interface with a USM-810 and USP-2 cards. The USM-810 Control Panel will not load in IQ for Windows and an error code of 16320 is displayed.
	I am using a 10k potentiometer on the USM-810 Control Port and it is not working.
	When running an IQ for Windows Roll Call the Interface is discoverd but no IQ devices are seen.
	What PIP modules are compatable with what amps?
	With two or more USM-810's in a IQ system engaging the preset in one of the USM-810's (that is not the Interface) causes the unit to lock up and go offline. Aftera period of time the unit comes back on line.

Crown Audio by Harman