Jump to content


Stephane

Member Since 23 Apr 2006
Offline Last Active Mar 04 2014 03:57 PM
-----

Posts I've Made

In Topic: Is it safe to run this amp with this speaker setup?

16 January 2014 - 12:24 AM

So according to the spec sheet your sub is 4 ohms. for your peavey speakers they are good for about 300 watts each, so would be careful to not push the amp too much because chance are you will burn some voice coil. Yoursub i'm not familar with the brand and by looking at the spec sheet they are not concistent with their spec on one page they say 1200watts  rms and the other 1600 watts rms. I would make sure to have a hipass set around 40 or 45 hz to avoid damage again. For your other question your amp is running at 4 ohms on but side so no big deal for the amp, it is rated for 2 ohms.

In Topic: Is it safe to run this amp with this speaker setup?

15 January 2014 - 08:13 AM

Safe for the amplifier or speakers? could you please list your speakers (brand and model), that would help to figure out stuff.

In Topic: Crown XTI 1002 amp in 4 ohm mode

03 January 2014 - 07:54 AM

Those speaker are rated 4 ohms so you cannot hookup two in parrallel on your amp in bridged mode. You should set your amp in stereo mode.

In Topic: Crown XTI 1002 amp in 4 ohm mode

02 January 2014 - 08:22 AM

What  kind of setup are you looking for??? You just have to plug the speaker and play music, what brand,model of speaker are you refering to? Speaker are not running anything amplifier will though.

In Topic: Part Needed For Crown Amp XLS 202

09 June 2013 - 01:27 PM

this is called a resistor, why you think it needs to be replace? go to the support tab of crown web site and download the shcematic for your amp and call them directely they will get you what you need.