new amp just arrived! I-Tech 4x3500 HD
speakers are the same ( 6xVRX 932, 2xSRX728S)
so I'm fighting with presets again
when using default setup no. 39 from VRX900 Passive V5 R1 set called "VRX932LA-1 3x LT 80 / VRX918S" I'm not able to edit xover, eq and delay ..
should I start with my own preset from scratch or shall I somehow modify this setup? If so, then how to unlock it? When I make a copy of this preset, it's still locked..
Output limiters are set to 169,1V PEAK, 60V RMS.. and no attack parameter, just release set to Manual.
Do you need some help with the IT8000 repair? If so, please describe your issue.
Thank you for your offer. First I'll try to let my Crown amp supplier repair my iT8k.
The issue is that when I switch it on, everything works as is supposed. Let's say the sound check of a band is over and the gig is to start shortly. When first sound comes out from my speakers after some time of silence between soundcheck and gig, one channel works fine but the other one "is very quiet". If I rise my master fader a bit higher, this quiet channel starts to work suddenly as it is supposed. It just needs some more signal to break the "gate"..
after some time of using iT 8000 with 6 VRX 932 some technical problems came with the amp. So now I have to make a decision, what will be my next step. So far I would like to try bi-amp wiring for my VRX's.
Will anybody give me a piece of advice what amp to choose?
As my iT8000 is half gone (one channel woks, the other doesn't sometimes, but sometimes does...) All that I can use is 2x XTI 4002 so far.
What amp should I look for?