Hello! I am looking for some advice on how to use a 'Tronographic Rusty box' pedal as a pre-amp with a Crown XLS 402.
I am a bass player and have just purchased a second hand Crown XLS 402. The idea was to use a 'Tronographic Rusty box' pedal as a pre-amp into the XLS 402 and use a single channels output to an Ampeg 4x10 (500w @4ohm).
As the XLS 402 only has XLR inputs, I am using a 1/4" jack to female XLR running from the Rusty Box's Line output into the XLS's 1st channel input.
I have stripped down one end of an old Speakon cable and have exposed the black and red cables. I have attached the red and black bare wire to the binding posts of Channel 1's output.
I was hoping to use just one side of the stereo output, 450w @4ohm, to power my speaker cabinet. Is this possible or have I totally dropped the ball?
Has anyone else been successful with this type of setup?
I would appreciate any feedback.
ShellacMember Since 23 Feb 2014
Offline Last Active Feb 23 2014 11:36 AM
- Group Members
- Active Posts 1
- Profile Views 1,093
- Age Age Unknown
- Birthday Birthday Unknown
Shellac hasn't added any friends yet.
No latest visitors to show