Jump to content


xtrememachines

Member Since 13 Jul 2013
Offline Last Active Mar 27 2014 12:48 PM
-----

Posts I've Made

In Topic: CTS1200 Static both channels

27 March 2014 - 12:50 PM

If I leave it on smoke starts to come out of the side the power plug is on.

In Topic: CTS1200 Static both channels

20 March 2014 - 11:28 AM

Can these amps be powered up with no speakers connected?
I pulled the amp out of the rack and powered it up on the bench with no load and it flashes fault and clip.

In Topic: CTS1200 Static both channels

19 March 2014 - 10:40 AM

I just went to test it out and when I turn it on I get no sound at all and the Ready lights are off, but the number 2 ready light and the data light on the back side are on but barley visible unless you get real close to see them.

In Topic: Cts600 data light flashing

31 October 2013 - 01:12 PM

Can I check the voltage form the top or do I have to pull out the board and check from the bottom.

In Topic: Cts600 data light flashing

31 October 2013 - 08:41 AM

It came with the standard card but I switched it out for the PIP Lite. I have it on the bench now I'll check the heat sinks and c933.