Jump to content


loginov

Member Since 16 Jun 2013
Offline Last Active Dec 02 2013 03:25 AM
-----

Posts I've Made

In Topic: Crown XTI 2 limiter

21 June 2013 - 04:09 PM

I can't find signs when the threshold is exceeded by the signal, in SA and BM !
How can I calibrate PA, after load preset, in this case not understand ... :unsure:



Posted Image
Posted Image

Posted Image



Can you look at the pictures above and answer, the threshold is exceeded by the signal or not ??? :o
Riddle? ))))))))))))

In Topic: Crown XTI 2 limiter

21 June 2013 - 08:31 AM

I have not received an answer to my main question, which related with speaker protection.


When the threshold is exceeded by the signal, my speakers get maximum power (for example: dbfs=0) !!!
When did threshold is exceeded by the signal???
What can point to it???

In Topic: Crown XTI 2 limiter

21 June 2013 - 03:58 AM

View Postdakos, on 21 June 2013 - 12:14 AM, said:

Could it be that you get confused between clipping and limiting? Make sure you understand exactly what each one of those mean!!!

I mean red flash on front panel, when limiter correct signal in the output, but this related only xti1, unfortunately.

In Topic: Crown XTI 2 limiter

21 June 2013 - 03:50 AM

View Postdakos, on 20 June 2013 - 12:06 PM, said:

All you need to do is connect the XTi to a laptop with SA, wirelessly or not, and monitor the limiter indicator. There is minimal support for connecting this amp to your computer wirelessly so you'll need to do your own research from previous posts here and on other forums.

Here is a good thread to start:
http://www.crownaudi...?showtopic=4392

Let us know how you plan to continue...
Avi

Many thanks!
I find this as the only possible solution

But does not understand the lack of gain redaction of limiter.
Gain reduction is essential to calibrate the system.

In Topic: Crown XTI 2 limiter

20 June 2013 - 10:59 AM

Ok

For example.
I load preset for my speakers VRX932LA1. Then, I send signal to the input of amps (from the mixer) and calibrate it with output signal (after DSP).

How can I know: DSP limiting signal in the output or not (from the FOH place)? I need to monitor maximum signal in the output.

(Using dbx260 or another DSP, you can control input signal from the mixer and monitor limiting signal in the output by clipping on panel)