Jump to content


Rubes1520

Member Since 11 Dec 2011
Offline Last Active Jun 23 2014 01:00 PM
-----

Posts I've Made

In Topic: XTi 2000 & XTi 4000 Setup

23 June 2014 - 12:56 PM

Thanks for the tip and everyone's input on this!

In Topic: XTi 2000 & XTi 4000 Setup

23 June 2014 - 12:48 PM

Hi Avi,

Thanks for your reply. The CH1 & CH2 icons are enabled on the amp, as well as the Y input Icon.

Ruben

In Topic: XTi 2000 & XTi 4000 Setup

23 June 2014 - 11:06 AM

Guys, I apologize for the delay in updating this post.  The good news is that I was able to change a few settings on the amp that powers my subs, the xti4000, to get the bass that I was looking for.  I did not touch the xti2000 which powers my speakers. I will list the settings that were in place before and after I made the changes on the xti4000 amp.

Before:
  • The JBL Tunings file for my subs was loaded
  • Since I started with 1 sub at first, when I added the second sub to my setup, ch.1 was the only channel being utilized in the amp settings although each sub was connected to its own channel
  • Amp set to Y Input
  • XOV settings from the JBL Tunings file being used
  • Bridged Mode

After:
  • JBL Tunings file still being used
  • Set to Stereo mode to utilize ch.1 & ch2.
  • Set to Sum ch.1 + ch.2 (Y-Input)
  • Same XOV settings as before, however, I had to setup both channels as Independent but with the same settings for each.  Before I setup the channels as independent, low frequencies were coming out of one sub while normal sound came out the other.  Setting it to independent corrected this.
  • Limiter set to -3db
  • Subs no longer bridged.

I noticed a much better performance on the subs.  With that said, is there anything different that you would do as far as settings go?  Or do you see any problems with how I have my subs configured on the xti4000?

Thank you!

Ruben

In Topic: XTi 2000 & XTi 4000 Setup

05 June 2014 - 03:07 PM

I haven't powered up the equipment yet.  I have to get it from our storage facility.  I plan to do this sometime this weekend and will update this post with the amp settings.  Thanks for checking!

In Topic: XTi 2000 & XTi 4000 Setup

03 June 2014 - 01:28 PM

Hi guys,

Here is the link to the mixer that I'm using:  http://www.behringer...ucts/DX626.aspx

I'm using speakon cables for my subs and speakers. I do believe that the limiter is ON, I haven't pushed either amp into clipping.  I will plug in both amps as soon as I get a chance and will get you all of the information on the settings being used.

Thank you!