Lancester

Member Since 26 May 2009
Offline Last Active Aug 17 2016 11:24 PM
-----

Posts I've Made

In Topic: ITECH- 6000 acting up

15 August 2016 - 10:41 PM

I no longer have system architect as it went away with my last hard drive crash. I did purchase the cable from Crown, however since it has to be soldered in at one end I believe I will have to bite the bullet and send it in to Crown for repair. I don't know that I'm ready to take that on....

In Topic: ITECH- 6000 acting up

02 August 2016 - 09:18 AM

I did just notice a sticker that states "3+3 warranty". I'm guessing this means it has been factory serviced?

In Topic: ITECH- 6000 acting up

02 August 2016 - 09:08 AM

Hello. I was going to post a picture of this amp, but the posting of pictures is either not allowed or I'm too inept to figure it out. I do have another 6000 I could un-rack and compare to. The cable is greyish with a black header, but I see no glue. Is this something I can purchase directly from crown? Also, could you possibly post a link to the proper firmware and software updating procedures? The link I have been trying doesn't seem to be working. Again, thank you for your time.

In Topic: ITECH- 6000 acting up

01 August 2016 - 04:05 PM

Thanks for the reply. Knowing what it costs for flat rate repair on these, it would be nice if I could repair it on my own bench. I was going to upload a photograph of the open case to see if you could point out which cable you speak of, but It looks like that is not allowed. Is it the long cable that bends around close to the channel one side?