CL1 going haywire, please help!

1 reply to this topic

#1 jaynez

  • Members
  • 1 posts

Posted 31 March 2006 - 08:12 PM

Hello, my problem with my CL1 450W amp is when I turn on power the blue power led ligts for about 5 seconds, then the fault and clip leds on both sides flash on and off to finally rest at where both fault leds are lit and the channel 1 clip led is lit. Can anyone help me with this?

#2 DGlass



  • Members
  • PipPipPipPipPip
  • 2,541 posts

Posted 12 April 2006 - 12:22 PM

It is hard to say what would be wrong as this is a fault conditions status were the amp is protecting itself. The amp will either need to come back to Crown for service or you can check our web site to see if there is a Crown Certified Service Center near you.