Have an itech 6000 and every 6 minutes the screen goes dark the amp seems dead other than power lights then comes back on again. Have gone right back to V1.2 and it still does the same thing.
I've heard this is because firmware upgrade is not done "properly"
Have followed instuctions to the letter with no success.
Whats going on here. I currently have 3 amps doing this
2
itech Problems
Started by mmeissner, Feb 22 2006 08:11 PM
3 replies to this topic
#2
jgriggs
-
- Members
- 14 posts
Posted 23 February 2006 - 10:24 AM
This started after upgrading to what firmware version?
Did these amplifiers exhibit this before upgrading?
Curious mind just want to know...
Jon
Did these amplifiers exhibit this before upgrading?
Curious mind just want to know...
Jon
#3
mmeissner
-
- Members
- 2 posts
Posted 23 February 2006 - 05:22 PM
QUOTE(jgriggs @ Feb 23 2006, 10:24 AM)
This started after upgrading to what firmware version?
Did these amplifiers exhibit this before upgrading?
Curious mind just want to know...
Jon
Did these amplifiers exhibit this before upgrading?
Curious mind just want to know...
Jon
Have gone back from 2.0 to 1.2 and back again and with each version amp does the same thing. Started happening after upgrade in Jan.
#4
DGlass
-
- Members
-
- 2,541 posts
.
Posted 24 February 2006 - 10:56 AM
Michael,
Kip and myself have already been working with you and Jands, there in Australia, on this issue. When an issue fix is found we will post a response here on the forum for everyone to see. Otherwise we will continue to respond to you and Jands via Email to resolve your issue.
Kip and myself have already been working with you and Jands, there in Australia, on this issue. When an issue fix is found we will post a response here on the forum for everyone to see. Otherwise we will continue to respond to you and Jands via Email to resolve your issue.
