Loading new firmware doesnt solve the problem.
Any Ideas ??????
This is becoming a major problem after already waiting nearly 3 weeks for the new input PCB, do I need a new DSP PCB as well.....
Best regards
Anders Fiedel
AV Center Aalborg
Denmark
1
USM810 Error Code E13
Started by fiedel, Dec 09 2005 04:07 AM
1 reply to this topic
#1
fiedel
-
- Members
- 1 posts
Posted 09 December 2005 - 04:07 AM
I have replaced the input PCB, due to a faulty input, after installation the unit wont boot correct, it reboots after the error code E13.
Loading new firmware doesnt solve the problem.
Any Ideas ??????
This is becoming a major problem after already waiting nearly 3 weeks for the new input PCB, do I need a new DSP PCB as well.....
Best regards
Anders Fiedel
AV Center Aalborg
Denmark
Loading new firmware doesnt solve the problem.
Any Ideas ??????
This is becoming a major problem after already waiting nearly 3 weeks for the new input PCB, do I need a new DSP PCB as well.....
Best regards
Anders Fiedel
AV Center Aalborg
Denmark
#2
DGlass
-
- Members
-
- 2,541 posts
.
Posted 09 December 2005 - 12:56 PM
Getting things shipped, through international customs and delivered can take up some time.
An E13 error code on the USM810 is a SHARC 3 Interface hardware error. I would try reflowing the solder for SHARC 3 on the SHARC board. If that fix the issue than you will need a new DSP/SHARC board.
An E13 error code on the USM810 is a SHARC 3 Interface hardware error. I would try reflowing the solder for SHARC 3 on the SHARC board. If that fix the issue than you will need a new DSP/SHARC board.
