Jump to content


Crown CE-1000


  • Please log in to reply
1 reply to this topic

#1 ryantoast

ryantoast
  • Members
  • 1 posts

Posted 18 October 2005 - 03:06 PM

Help Needed!

what is the correct wiring procedure to mirror a single input to both sides of a Crown CE-1000? which terminals get connected to what?

Thanks in advance


ryandowney@mac.com

#2 DGlass

DGlass

    .

  • Members
  • PipPipPipPipPip
  • 2,541 posts

Posted 19 October 2005 - 09:03 AM

To be able to get the same signal on both channels from one input. Install a jumper wire from the + termnal of the channel 1 barrier strip connection to the the + terminal of the Channel 2 barrier strip connection. Then install a jumper wire from the - termnal of the channel 1 barrier strip connection to the the - terminal of the Channel 2 barrier strip connection. You will not need to put in a ground wire jumper as ground is already common to both channels.
This would be the same as putting an XLR "Y" cable on the input XLR connectors allowing you the have the same input signal from a single XLR connection to both input channels of the amplifier.