Jump to content


amps for my high ends


  • Please log in to reply
No replies to this topic

#1 binsoy25

binsoy25
  • Members
  • 7 posts

Posted 15 October 2005 - 03:56 PM

Hi. The high end drivers of my system consists of 2 pairs of peavey RX 22 -8 ohms, one pair on each side wired in parallel. The rx 22 is rated at 70w rms and 140w prog so I got 280w @ 4 ohms per side.  I was looking for an amp that would match to the wattage of the drivers like an amp rated at 280w /channel @ 4 ohms. But i never found that kind of amp usually the amp that I found is rated at 300w per channel @ 4 ohms.  If I use the 300w/channel amp is it  too much already for the drivers. There were other amps that i found rated at 200w/channel some are 230w/channel @ 4 ohms but it seems i am underpowering the drivers if i use them. Any advise and recommendation. Thanks and more power.