Hey,
I'm sure I'm doing something really stupid but when I set an I-Tech 6000 up the other day it seemed to be stuck on "Y" input no matter what setting I made on the IQ-Wic software (on the block diagram screen for the amp).
Is there something I'm missing here is there somewhere else this can be set? Need to run in stereo.
ites.,
cathal.
1
I-Tech....Y input?
Started by rezsbc, Sep 26 2005 06:02 AM
1 reply to this topic
#2
Bradford Benn
-
- Admin
-
- 1,025 posts
Power User
Posted 26 September 2005 - 08:05 PM
QUOTE(rezsbc @ Sep 26 2005, 06:02 AM)
Hey,
I'm sure I'm doing something really stupid but when I set an I-Tech 6000 up the other day it seemed to be stuck on "Y" input no matter what setting I made on the IQ-Wic software (on the block diagram screen for the amp).
Is there something I'm missing here is there somewhere else this can be set? Need to run in stereo.
ites.,
cathal.
I'm sure I'm doing something really stupid but when I set an I-Tech 6000 up the other day it seemed to be stuck on "Y" input no matter what setting I made on the IQ-Wic software (on the block diagram screen for the amp).
Is there something I'm missing here is there somewhere else this can be set? Need to run in stereo.
ites.,
cathal.
There are actually two places you can make this adjustment. One is the input "Y" as you mentioned. The other place to check is the Input Section and make sure that the amplifiers are receiving signal from the proper channels
Attached Files
-
SNAG_0619.png 57.42K
33 downloads
