Jump to content


XLS1500 mono mode

mono

  • Please log in to reply
5 replies to this topic

#1 chuckpuckett

chuckpuckett
  • Members
  • 3 posts

Posted 30 May 2014 - 09:48 AM

Good morning! (it is here, at any rate)

I would like to use my XLS1500 so that I take a mono signal from the mixer, obtain outputs on Ch 1 and Ch 2 (not bridged, no hi or lo pass filters). This seems a simple enough configuration, but for the life of me, I can't deduce how to accomplish this from the manual, nor by deduction from cycling thru amp modes on the device itself.

Can someone point me in the right direction?

Thanks!
Chuck Puckett
www.puckettpublishing.com
"I don't want to steal the show... I only want to borrow it for a while."
"Against stupidity the gods themselves strive in vain."

#2 dakos

dakos

    Admin

  • Members
  • PipPipPipPipPip
  • 762 posts

Posted 30 May 2014 - 12:39 PM

The following steps should do the job but since I don't actually own this amp I'll wait for you to confirm.
Follow these steps:
1. Hold the "Mode/Menu" button down for 3 sec until the LCD screen displays "Amp Mode <More>"
2. Press the "Mode/Menu" button to begin configuring the Amp Mode.
3. Press the "Next" button until the LCD screen displays "Input Y".
4. Now press the "Mode/Menu" button to confirm.
5. The LCD screen should now read "Input Y".

Optionally you may use a simple Y cable.
Let me know if it went well.
Avi

#3 dakos

dakos

    Admin

  • Members
  • PipPipPipPipPip
  • 762 posts

Posted 30 May 2014 - 01:23 PM

Watched a few of your songs... Great work, I really liked them :)

#4 chuckpuckett

chuckpuckett
  • Members
  • 3 posts

Posted 30 May 2014 - 03:08 PM

Thanks. Just getting ready to go over to the shed and try your solution.
We play a lot of coffee house gigs, so powered Behringer mains is generally sufficient. Next week, I'm providing sound for an outdoor benefit concert, all acoustic groups. But I need the extra oomph being outside. Will let you know how it goes.
Chuck Puckett
www.puckettpublishing.com
"I don't want to steal the show... I only want to borrow it for a while."
"Against stupidity the gods themselves strive in vain."

#5 chuckpuckett

chuckpuckett
  • Members
  • 3 posts

Posted 30 May 2014 - 06:14 PM

Just to let you know: that worked perfectly. And I dedicated an Aux Out to the Crown so I could control it's output independently of the Main/Sub channel faders. Everything is cooking, clear and LOUD. And clear. Good device.
Thanks again.
Chuck Puckett
www.puckettpublishing.com
"I don't want to steal the show... I only want to borrow it for a while."
"Against stupidity the gods themselves strive in vain."

#6 dakos

dakos

    Admin

  • Members
  • PipPipPipPipPip
  • 762 posts

Posted 31 May 2014 - 11:51 AM

Great to hear that. Keep on the good work :)





Also tagged with one or more of these keywords: mono