Jump to content


IQWic - Pilot Tone


  • Please log in to reply
1 reply to this topic

#1 sysco-chris

sysco-chris
  • Members
  • 1 posts

Posted 19 May 2014 - 03:17 AM

I have just installed 6 new CTs2000 amplifiers with the PIP-USP3/CN Module installed in them. I have to use IQWic to control and the amplifiers as we are monitoring the amplifiers via Peavey NWare for which we have a Plugin. I have setup all the various buttons I need, but cannot get to Pilot Tone Enable, Pilot Tone Low Current Threshold, Pilot Tone High Current Threshold controls. I can see the controls if I set up a Scene but not when trying to attached the controls to the screen controls. Looks like there are two lists that go with the PIP Module.

#2 dakos

dakos

    Admin

  • Members
  • PipPipPipPipPip
  • 772 posts

Posted 19 May 2014 - 07:53 AM

Hi there Chris,

Your question is not as typical as you'd think so you'll be better served if you contact the tech support directly via telephone.
http://www.crownaudio.com/techsupp.htm

Avi