Jump to content


XTi 2002 no output signal


  • Please log in to reply
1 reply to this topic

#1 Wry The Bteam

Wry The Bteam
  • Members
  • 1 posts

Posted 22 February 2014 - 07:35 PM

Hey people i have just connected my new xti 2002 to bandmanager 2

input is mono into Ch 1 (Y)

Ch 1 output is going to subs

Ch 2 output is going to mid/high boxes

Output mode is in Dual

In Band manager 2 I have setup the Xover to 135 Hz, i have also setup a hard limit at 35v for both outputs. There are no EQs activated.

The problem is is that i can see the input signal coming in from my desk but cannot see any output signal. When i turn the amp up via the knobs on the front panel there is no sound coming out of the speakers. However, when i go into the input section i can activate the pink noise and it comes out of the speakers.

Also if i crank the input gain right up beyond clipping and turn the channels right up i can hear the sound leaking through the amp..

The pink noise works fine so ive got the PA hooked up correctly, im assuming im missing something on the sofware setup side of things.

Any help or suggestions would be greatly appreciated.

#2 joust

joust

    Power User

  • Members
  • PipPipPipPipPip
  • 450 posts

Posted 24 February 2014 - 11:18 AM

Does the unit operate well (pass signal) in Dual mode and preset DSP OFF?
When the unit has finished booting up, the Ready indicators should come on.
With signal coming in, the Signal led (second led from bottom) should be lit. If it is not, verify and confirm you have signal coming to the XTI.