Keeping the Xti2000 vertically ? yay or nay?
Posted 14 December 2013 - 09:25 PM
I've had this amplifier for a good 7-years, when they came out I think... lol, I must say it is still rock solid and pumping the power I need!
Anyways, silly question but I just want to be safe and keep this thing going strong for a lifetime I hope lol... I'm thinking of setting up the amplifier vertically due to space concern, but I would'nt do it if it has a potential to damage or mess up something internally on the long run... Thinking of keeping it vertically for about 2years....
-- X-fi Elite--
-- B&W 685 Bookshelves --
-- TC Sound TC-10OEM --
-- Rega Cursa3 --
-- Rega Exon3 Monoblock (x2) --
-- Crown XTi2000 --
-- Art Cleanbox --
Posted 16 December 2013 - 03:32 AM
The problem with positioning the amp vertically is that heat goes up so if the amp is vertical the heat would go into the circuit board and not into the heat sinks for the fan to evacuate. So that's a nay :-)
Posted 16 December 2013 - 09:55 AM
Now, if you schedule the amp to enable the fan at power up (power down, press on MENU switch and while keeping MENU pressed, power up) the heat may be less prevalent than if the fan was not enabled. So, it may be a 'yay'! :-)
Posted 17 December 2013 - 07:16 AM
How much of the heat would you say travels into the heatsink due to physical connection and not due to the amps position? Or in other words how much heat would stay in the board if the amp would be on the side or even upside down?
Just so you see why I said Nay...
Specifically look at the thermal pictures.
Keep in mind that the cover is off therefore ventilation could be impaired.
Posted 17 December 2013 - 09:48 AM
Posted 17 December 2013 - 04:27 PM
I have put the XTI in a vertical position with no ill effect (that I could see!). Yes, I did see the images; I gather that perhaps the top cover was open. Also, the unit was an XTI1000. It doesn't have the Tracker module installed. The XTI2000 does have the Tracker module. The Tracker module is a glorified bi-level switch, that helps out to keep the amp cool when the amp is in low power mode. Also, like I mentionned above, if the fan is activated upon power up, the heat should not accumulate in any appreciable amount.