Jump to content


Strange issue with signal/ IOC led.


  • Please log in to reply
2 replies to this topic

#1 techie47

techie47
  • Members
  • 13 posts

Posted 21 April 2013 - 03:35 AM

I have a Crown MA1200 that has a very strange issue.

When you power it up ,the channel one signal/ioc green led comes on and goes off when the relay clicks on. However, on channel two, the green led does not come on at all.  The odep led stays lit bright on both channels.  I know that is normal for odep led to stay on.
Has anyone seen this type of  problem before?

#2 joust

joust

    Power User

  • Members
  • PipPipPipPipPip
  • 479 posts

Posted 22 April 2013 - 11:39 AM

Hello techie47,

This issue could very well be a display board problem. You may have a faulty led, or, perhaps, the load resistor or switch is open. Verify the IOC drive on the display board.
Also, can you tell us if the Ch2 output comes up normally?

Alain

#3 techie47

techie47
  • Members
  • 13 posts

Posted 25 April 2013 - 09:24 PM

I will hook it up to speakers and let you know.