Jump to content


connections

connections wiring bridge mono subs

  • Please log in to reply
2 replies to this topic

#1 2dmax

2dmax
  • Members
  • 2 posts

Posted 22 October 2012 - 11:28 PM

Hi guys hope am in the right place, i would like to know is, how to connect my subs when using BRIDGE MONO or BRIDGE SUB'S preset on my xti 2000
i'm not sure if i still need to connect my speaker cable to the 2 positive terminals (red banana plugs) or conf. my speakon cable to the +1 +2  although i've set the
amp to bridge mono or bridge subs

amp - XTI 2000
speaker -   B&C 18 TBW100
8 Ohms - 96dB SPL
  • 1,500 Watts AES Standard
  • 3,000 Watts Program

4 POLE SPEAKON CABLE

#2 dakos

dakos

    Admin

  • Members
  • PipPipPipPipPip
  • 743 posts

Posted 23 October 2012 - 05:19 AM

Hello and wolcome to the forums :)
Either way would work so which ever you feel more comfrtable with, if you need to dissasmble the rig many times I'd go the Speakon route, just make sure the polarity is correct acording to the manual (page 13, section 2.6.2) and if you go the speakon route make sure you mark the amp side of the cable clearly.

#3 2dmax

2dmax
  • Members
  • 2 posts

Posted 23 October 2012 - 08:32 AM

Thanks Dakos, will go ahead and make the changes, I just wasn't sure if its a step needed although the amp was switched to bridge mode already.
Thanks again for your quick reply.