CTs 4200 is dead

Service Manual

2 replies to this topic

#1 color.line

  • Members
  • 1 posts

Posted 18 September 2012 - 08:21 AM


Got a CTs 4200 that died on me, and I need a service manual to get it back up running.
Work on a cruise ship so going to a dealer is not a solution for me.
If you have an idea what could be wrong if I say that all lights were RED and after turning it off it never came back on.

But a service manual would help to trace the problem down and change parts.


#2 dakos



  • Members
  • PipPipPipPipPip
  • 791 posts

Posted 18 September 2012 - 12:44 PM

Just contact any one of the support team, they are usually very helpful with amp schematics...

#3 joust


    Power User

  • Members
  • PipPipPipPipPip
  • 774 posts

Posted 09 October 2012 - 10:22 AM

It looks like you have a low voltage issue.
Investigate the low voltage (LV) psu for cold solder connections.
Remove the psu connector to the main board and measure the DC voltages (+5, +15, -15).
If you should see some bulging caps, I would highly recommend that you replace the LV module.