3 replies to this topic

[piruloy2k]

Hi Team;
Actually I'm running  my two (2) XTI2000 amps with this config:

one xti2000 in Stereo Mode with two (2) 8-omh speakers on each Channel, on pararell (4omh both channels)
one xti2000 in Bridge Mode with two (2) 8-omh subs connected in parallel to channel one (4 omh load)

Surely on my Subs amplifier I think I have the best setup . If not, let me know.

In case of the other amp, is this setup OK, or how I can get the most of this Amp?
Can I run in on Bridge mode and connect all four speakers in parallel to a 2omh load?
Can this improve my sound power?

Thanks;
Carlos Brea
Puerto Rico

[Stephane]

Hi Team;
Actually I'm running  my two (2) XTI2000 amps with this config:

one xti2000 in Stereo Mode with two (2) 8-omh speakers on each Channel, on pararell (4omh both channels)
one xti2000 in Bridge Mode with two (2) 8-omh subs connected in parallel to channel one (4 omh load)

Surely on my Subs amplifier I think I have the best setup . If not, let me know.

In case of the other amp, is this setup OK, or how I can get the most of this Amp?
Can I run in on Bridge mode and connect all four speakers in parallel to a 2omh load?
Can this improve my sound power?

Thanks;
Carlos Brea
Puerto Rico

Minimum load in bridged mode is 4 ohms

[Tom Lureman]

Do not plug in all 4 speakers to make a 2ohm load on bridge mode.  Like Stephane said, 4ohms is the minimum in bridge mode.  In stereo it can go down to 2ohms per channel.

[piruloy2k]

Do not plug in all 4 speakers to make a 2ohm load on bridge mode.  Like Stephane said, 4ohms is the minimum in bridge mode.  In stereo it can go down to 2ohms per channel.

Ok thanks for the suggestions!