1 reply to this topic

[piruloy2k]

Hi Team;
I have an xti 2000 running two Peavey 18" Black Widow  chained ( run at 4omh)
Rigth know i just set the amp to Bridge Sub, and connect one sub to channel A and connect the other
to the sub.
System works ok, but I want to get out the most from my system.
Im a newby on this, close to one year, and theres a lot of settings to change at the software ( corssover, eqs, etc etc)
Is theres a recommended setting to get the most out of this subs?
Thanks!

Carlos
Puerto Rico

[Tom Lureman]

How are you connecting to "channel A"  I'm assuming this is channel 1 and that you are using speakon?  If you are using speakon, on the AMP END ONLY, the connector must be wired to 1+ and 2+.  You may want to google search using speakon connectors in bridge mode.

Otherwise use banana connectors or bare wire and connect to the two red terminals instead of speakon.