Currently running this amp on stereo high pass. How do I get this back on stereo bypass? I run through the menu and everything come up except that.
Also would like to run one dual 15's 700 watts program 4 ohm rating and one single 15 400 watts program 8 ohms rating in paralell off each side. Would this amp handle it?
0
XLS 2500 Questions
Started by Spencer Stremich, Nov 13 2011 11:40 AM
1 reply to this topic
#2
Tom Lureman
-
- Admin
-
- 111 posts
Network Newbie
Posted 29 November 2011 - 11:16 AM
Hold down the MODE button until it says "AMP MODE"
Release the button and press it again.
It should say "STEREO" already, so press the MODE button again.
Now it will say "HIGHPASS", press the NEXT button until you see "BYPASS" and press the MODE button.
At this point the amp should say STEREO BYPASS
Release the button and press it again.
It should say "STEREO" already, so press the MODE button again.
Now it will say "HIGHPASS", press the NEXT button until you see "BYPASS" and press the MODE button.
At this point the amp should say STEREO BYPASS
